淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

System Simulator >
System Component Models >
Miscellaneous >
Multiplexer, Real (RMUX)

Multiplexer, Real (RMUX)

Property	Description	Units	Default	Range/Type
TYPE	Output sampling rate changed: 1 for Yes, 0 for No	None	0	[0, 1]/Integer
NS1	Number of samples to read from input1 per cycle	None	1	[1, Inf)/Integer
NS2	Number of samples to read from input2 per cycle	None	1	[1, Inf)/Integer
RIN1	Input1 impedance	Ohm	Inf	(0, Inf]/Real
RIN2	Input2 impedance	Ohm	Inf	(0, Inf]/Real
ROUT	Output impedance	Ohm	0	[0, Inf)/Real
Ports
Input1	Input1 signal (real)
Input2	Input2 signal (real)
Output	Multiplexed output signal (real)

Notes

This model multiplexes two real input signals with the same sampling rate into a single real output signal. The output signal takes NS1 samples from the first input, and then NS2 samples from the second input, and then NS1 samples from the first input again, and so on until no data is available for processing. If TYPE is set to 0, then the sampling rate of the output signals will not change. Otherwise, the sampling rate of the ith output port can be calculated as

Netlist Form

RMUX:Name n1 n2 n3 NS1=val NS2=val [TYPE=val] [Rin1=val] [Rin2=val][Rout=val]

Netlist Example

RMUX:1 1 2 3 NS1=45 NS2=100

In this example, the multiplexed real output signal will consist of 45 samples from Input1 followed by 100 samples from Input2 followed by 45 samples from Input1 and so on until no more input samples exist at one or both input nodes

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com