淘宝官方店推荐课程在线工具联系方式关于我们

	微波射频仿真设计 Ansoft Designer 中文培训教程 \| HFSS视频培训教程套装
	Agilent ADS 视频培训教程 \| CST微波工作室视频教程 \| AWR Microwave Office

首页 >> Ansoft Designer >> Ansoft Designer在线帮助文档

Ansoft Designer / Ansys Designer 在线帮助文档：

System Simulator >
System Component Models >
Miscellaneous >
Demultiplexer, Complex (CDMUX)

Demultiplexer, Complex (CDMUX)

Property	Description	Units	Default	Range/Type
Type	Output sample rate changed: 0 for No, 1 for Yes	None	0	[0, 1]/Integer
NS1	Number of samples to write to output1	None	1	[1, Inf)/Integer
NS2	Number of samples to write to output2	None	1	[1, Inf)/Integer
RIN	Input impedance	Ohm	Inf	(0, Inf]/Real
ROUT1	Output1 impedance	Ohm	0	[0, Inf)/Real
ROUT2	Output2 impedance	Ohm	0	[0, Inf)/Real
Ports
Input	Input signal (complex)
Output1	Output1 signal (complex)
Output2	Output2 signal (complex)

Notes

This model demultiplexes one complex input signal into two complex output signals. It works as follows: the first output reads NS1 samples from the input signal, then the second output reads NS2 samples from the incoming signal, then the first output reads again, repeating the pattern until there are no more data to be read. Based on whether the parameter “type” is set or not, the sampling rate of the two output signals can change or remain the same. Suppose the sampling rate of the input signal is , if TYPE is set to be 1, then the sampling rate for the two outputs would be and respectively.

Netlist Form

CDMUX:Name n1 n2 n3 [TYPE=val] NS1=val NS2=val [Rin=val] [Rout1=val] [Rout2=val]

Netlist Example

CDMUX:Name 1 2 3 NS1=20 NS2=30

HFSS视频教程 ADS视频教程 CST视频教程 Ansoft Designer 中文教程


Copyright © 2006 - 2013 微波EDA网, All Rights Reserved 业务联系：mweda@163.com