Frequency Range Settings
Settings  Frequency
This dialog box provides everything to define the frequency range of
your project.
It is important to know that these settings have some influence on
the calculation results, that is why you have to choose Fmin and Fmax
properly.
No meshing and therefore no calculation is possible without specifying
the frequency range.
Fmin
Enter a valid
for the lower frequency of a stimulation signal and all signal monitors.
The unit for the frequency setting is specified
in the Units dialog box and is
displayed in the
.
Fmax
Enter a valid
for the upper frequency of a stimulation signal and all signal monitors.
The unit for the frequency setting is specified
in the Units dialog box and is
displayed in the
.
OK
Performs your settings and leaves the dialog
box.
Cancel
Closes this dialog box without performing any
further action.
Help
Shows this help text.
See also
Automesh,
Units
HFSS视频教程
ADS视频教程
CST视频教程
Ansoft Designer 中文教程
|
淘宝官方店 
